Datapath VSN990 Manuale Utente Scaricare il pdf (Pagina 9)

Use of the SBC’s onboard graphics adaptor

Onboard Graphics Adaptor used as Control Screen

The VSN990 is shipped with the BIOS congured to boot o the onboard graphics device. This output can

then be used as the control screen for a typical wall conguration.

To set the system to boot on the onboard graphics device (“Internal Graphics Device” - IGD), enter setup

from the boot screen by pressing <DEL> as prompted.

In the BIOS setup utility select:

Chipset>North Bridge Conguration>Initiate Graphic Adapter - [IGD]

Chipset>North Bridge Conguration>PEG Port Conguration>PCI Express Port - [Auto]

Onboard Graphics Adaptor Disabled

If you do not require a control screen, then you should disable the integrated graphics as described below.

Connect a monitor to the onboard graphics device output and enter setup from the boot screen by

pressing <DEL> as prompted.

In the BIOS setup utility select:

Fig.5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Nessun commento

Datapath VSN990 Manuale Utente Pagina 9